Products

News

Contact Us

Phone

Current Position > Products

Product Name: 3D Printer controller MKS Gen V1.2 for Arduino with USB Cable

Features:
1, 2560 and ramps1.4 collection on a board, solved the ramps1.4 combination interface trival, easily out of order.
2, can replace the motor driver, support 4988 drivers and 8825 drivers.
3, circuit board USES the high quality 4 layer board, and the thermal optimization; Ramps is 2 layer board.
4, using high quality MOSFET tube, the effect of heat dispelling is better.
5, using special power supply chip, support the 12 v and 24 v power input, solve the problem of Ramps voltage conversion chip fever.
6, can accept 24 v input, under the same system power can reduce the current hot bed to 1/4, effectively solve the problem of hot bed MOS tube heating.
7, firmware, you can use open source firmware Marlin, configuration and ramps1.4 are exactly the same, can be directly replace ramps1.4.
Eight, can be directly connected Ramps1.4, 2004 LCD control panel and the LCD panel (12864).
9, reserved motor pulse and direction of output port, convenient external large current to external large current (e.g., 2 a, 5 a) motor drive circuit.
10, retain Ramps1.4 Servos, AUX 1, AUX - 2 interface, provide 3 5 v output, 3 12 v output interface.